The projector is equipped with Bluetooth that allows the user to connect the projector to their Bluetooth device wirelessly for audio playback. Then connect the other end of the cable to the USB A port of your projector.Īdditionally, you can connect a keyboard, a mouse, dongles, storage devices, etc. However, the brightness level will be limited to 50% and 30% when the Light Source Level is set as Full or Eco respectively.Ĭonnect one end of a USB Type-A cable to the USB-A port of your device (if applicable). The M2e can also use a USB-C connected power bank to turn on the system.Ensure your USB Type-C device can support video transmission.Then connect the other end of the cable to the USB-C port of your projector. USB ConnectionĬonnect one end of a USB Type-C cable to the USB-C port of your device. NOTE: iPhone/iPad users will need to use an additional adapter. Then connect the other end of the cable to the HDMI port (it supports HDCP 1.4/HDMI 1.4) of your projector. Location and distance between the projector and other equipment.Ĭonnect one end of an HDMI cable to the HDMI port of your video device.Personal preference and room layout will decide the installation location. Dispose of used batteries according to the manufacturer’s instructions and local environment regulations for your region.Ĭhoosing a Location - Projector Orientation.If the battery is drained or if you will not be using the remote control for an extended period of time, remove the battery to avoid damage to the remote control.Replace only with the same or equivalent type recommended by the battery manufacturer.Avoid leaving the remote control and batteries in excessive heat or a humid environment.Replace the battery cover by aligning it with the base and pushing it back into position.Remove any existing batteries (if necessary) and install two AAA batteries.Remove the battery cover from the bottom of the remote control by pressing the finger grip and sliding it across. NOTE: Refer to the illustration for the location of the infrared (IR) remote control sensor(s).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |